Software Guide¶
This section walks you through setting up and configuring the RTA software after your hardware is connected.
Before You Begin¶
Make sure you have completed the Hardware Guide first:
- HDMI splitter connected with EDID copy mode enabled
- Capture card installed and detected
- Poker PC connected to splitter INPUT
- Monitor connected to splitter OUTPUT 1
- Capture card connected to splitter OUTPUT 2
Setup Checklist¶
Follow these steps in order for best results:
| Step | Section | What You'll Do |
|---|---|---|
| 1 | Capture Setup | Verify video signal and configure resolution |
| 2 | Image Quality Analysis | Analyze capture signal quality |
| 3 | Table Detection | Set up table detection rectangles |
| 4 | OCR Calibration | Configure card and stack recognition |
Quick Verification¶
After completing all steps, you should be able to:
- Click Render and see your Poker PC screen
- Click Show DL and see stable detection rectangles on tables
- Click Show OCR and see cards/stacks being read correctly
If any of these don't work, use the Troubleshooting Wizard to diagnose the issue.
Resolution Requirements¶
Both PCs must be configured correctly:
Poker PC
- Display scaling: **100%** - Resolution: Your preferred resolution (e.g., 2560x1440)OCR PC
- Display scaling: **100%** - Resolution: **Same as or larger than** Poker PCScaling Must Be 100%
Both PCs must have display scaling set to 100%. Any other scaling value will cause detection issues.